LabWired The easy way to build hardware
wireless part

Wi-Fi access point

The Wi-Fi access point is a wireless part in the LabWired part catalog. Its catalog type is wifi-ap. A device model in the simulation engine, reached through a dedicated dispatch path rather than the peripheral registry.

From the catalog: WiFi AP modelled by VirtualAp + SimNet (functional association + in-sim servers); attached from the compiled wifi_ap: system-YAML block, not a kit, so it is absent from the generated manifest.

Wi-Fi access point in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryWireless
Catalog typewifi-ap

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

How to simulate the Wi-Fi access point in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the Wi-Fi access point (catalog type wifi-ap).
  3. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.