LabWired The easy way to build hardware
I²C device

FXOS8700 Accel/Mag

The FXOS8700 Accel/Mag is an I²C device in the LabWired part catalog. Its catalog type is fxos8700. It connects to the MCU over I²C at the default address 0x1F. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

FXOS8700 Accel/Mag in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryI²C devices
Catalog typefxos8700
InterfaceI²C
Default I²C address0x1F (31 decimal)
Pins4
DatasheetNXP FXOS8700CQ datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

FXOS8700 Accel/Mag pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
SDA Open-drain I²C data (SDA)
SCL Open-drain I²C clock (SCL)

How to simulate the FXOS8700 Accel/Mag in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the FXOS8700 Accel/Mag (catalog type fxos8700).
  3. Connect VCC and GND to the supply and ground of the board.
  4. Connect SDA and SCL to the I²C data and clock pins of the board.
  5. Run the firmware. It finds the part on the I²C bus at 0x1F and reads and writes it as on hardware.

Related I²C devices

All I²C devices · All parts

Further reading

Modelled from NXP FXOS8700CQ datasheet.