LabWired The easy way to build hardware
UART device

IO-Link Master

The IO-Link Master is a UART device in the LabWired part catalog. Its catalog type is iolink-master. It connects to the MCU over UART. It has 5 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

IO-Link Master in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryUART devices
Catalog typeiolink-master
InterfaceUART
Pins5

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

IO-Link Master pinout

PinElectrical typeFunction
TX Output UART transmit (TX)
RX Input UART receive (RX)
L+ Power input Supply
CQ Bidirectional —
L- Power input Supply

How to simulate the IO-Link Master in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the IO-Link Master (catalog type iolink-master).
  3. Connect L+ and L- to the supply and ground of the board.
  4. Cross the UART lines: connect TX to the RX pin of the board, and RX to the TX pin of the board.
  5. Connect CQ as your circuit needs.
  6. Run the firmware. It sends and receives bytes on the simulated UART as on hardware.

Related UART devices

All UART devices · All parts