LabWired The easy way to build hardware
board I/O module

NeoPixel 8x8 Matrix

The NeoPixel 8x8 Matrix is a board I/O module in the LabWired part catalog. Its catalog type is neopixel-matrix. It connects to the MCU over GPIO. The catalog gives a supply range of 5 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: WS2812 8x8 matrix: same edge decoder as neopixel with num_pixels=64. Canvas shows columns/zigzag/top-left grid; core stores a linear strip.

NeoPixel 8x8 Matrix in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typeneopixel-matrix
InterfaceGPIO
Supply range5 V
Pins4
DatasheetWorldsemi WS2812B intelligent control LED datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

NeoPixel 8x8 Matrix pinout

PinElectrical typeFunction
DIN Input —
VCC Power input Supply
GND Power input Supply
DOUT Output —

How to simulate the NeoPixel 8x8 Matrix in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the NeoPixel 8x8 Matrix (catalog type neopixel-matrix).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 5 V.
  4. Connect DIN and DOUT as your circuit needs.
  5. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts

Modelled from Worldsemi WS2812B intelligent control LED datasheet.