LabWired The easy way to build hardware
SPI device

NeoPixel Ring 24

The NeoPixel Ring 24 is an SPI device in the LabWired part catalog. Its catalog type is neopixel-ring. It connects to the MCU over SPI. The catalog gives a supply range of 5 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: WS2812 24-LED ring: same edge decoder as neopixel with num_pixels=24. Canvas shows circular ring; core stores a linear strip. frames_seen for blink/dim.

Key facts

CategorySPI devices
Catalog typeneopixel-ring
InterfaceSPI
Supply range5 V
Pins4
DatasheetWorldsemi WS2812B intelligent control LED datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

NeoPixel Ring 24 pinout

PinElectrical typeFunction
DIN Input —
VCC Power input Supply
GND Power input Supply
DOUT Output —

How to simulate the NeoPixel Ring 24 in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the NeoPixel Ring 24 (catalog type neopixel-ring).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 5 V.
  4. Connect DIN and DOUT as your circuit needs.
  5. Run the firmware. It selects the part and moves bytes over the simulated SPI bus as on hardware.

Related SPI devices

All SPI devices · All parts

Modelled from Worldsemi WS2812B intelligent control LED datasheet.

Wire it up in Playground → See the full validation matrix