LabWired The easy way to build hardware
board I/O module

Hobby PWM Servo

The Hobby PWM Servo is a board I/O module in the LabWired part catalog. Its catalog type is servo. It connects to the MCU over GPIO. The catalog gives a supply range of 4.8–6 V. It has 3 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Hobby PWM Servo in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typeservo
InterfaceGPIO
Supply range4.8–6 V
Pins3

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

Hobby PWM Servo pinout

PinElectrical typeFunction
PWM Input PWM
VCC Power input Supply
GND Power input Supply

How to simulate the Hobby PWM Servo in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the Hobby PWM Servo (catalog type servo).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 4.8–6 V.
  4. Connect PWM to a pin that can output PWM.
  5. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts