IR Obstacle Sensor

The IR Obstacle Sensor is a board I/O module in the LabWired part catalog. Its catalog type is ir-obstacle. It connects to the MCU over GPIO. The catalog gives a supply range of 3.3–5 V. It has 3 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

From the catalog: Digital obstacle flag; host-driven via pad/SimInput.

Key facts

Category	Board I/O modules
Catalog type	ir-obstacle
Interface	GPIO
Supply range	3.3–5 V
Pins	3

What LabWired simulates

IR Obstacle Sensor pinout

• Power: VCC, GND
• GPIO: OUT

How to simulate the IR Obstacle Sensor in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the IR Obstacle Sensor (catalog type ir-obstacle).
3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 3.3–5 V.
4. Connect OUT to a free GPIO pin.
5. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

• IRF520 MOSFET Module GPIO · Pins only, by design
• INMP441 I2S Mic SPI · Built from the datasheet
• L293D GPIO · Built from the datasheet
• ILI9341 TFT (16-bit parallel) GPIO · Built from the datasheet
• L9110S Dual H-Bridge Motor Driver GPIO · Pins only, by design
• HX711 Load Cell GPIO · Built from the datasheet
• LED GPIO · Pins only, by design
• Hobby PWM Servo GPIO · Built from the datasheet

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.