LabWired The easy way to build hardware
I²C device

Sensirion SGP41 VOC/NOx

The Sensirion SGP41 VOC/NOx is an I²C device in the LabWired part catalog. Its catalog type is sgp41. It connects to the MCU over I²C at the default address 0x59. The catalog gives a supply range of 1.7–3.6 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Sensirion SGP41 VOC/NOx in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryI²C devices
Catalog typesgp41
InterfaceI²C
Default I²C address0x59 (89 decimal)
Supply range1.7–3.6 V
Pins4
DatasheetSensirion SGP41 datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

Sensirion SGP41 VOC/NOx pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
SDA Open-drain I²C data (SDA)
SCL Open-drain I²C clock (SCL)

How to simulate the Sensirion SGP41 VOC/NOx in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the Sensirion SGP41 VOC/NOx (catalog type sgp41).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 1.7–3.6 V.
  4. Connect SDA and SCL to the I²C data and clock pins of the board.
  5. Run the firmware. It finds the part on the I²C bus at 0x59 and reads and writes it as on hardware.

Related I²C devices

All I²C devices · All parts

Further reading

Modelled from Sensirion SGP41 datasheet.