The ULN2003 / 28BYJ-48 stepper is a board I/O module in the LabWired part catalog. Its catalog type is uln2003. It connects to the MCU over GPIO. The catalog gives a supply range of 5–12 V. It has 10 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.
| Category | Board I/O modules |
|---|---|
| Catalog type | uln2003 |
| Interface | GPIO |
| Supply range | 5–12 V |
| Pins | 10 |
| Datasheet | TI ULN2003A Darlington array datasheet |
Simulated device model
Built from the datasheet
| Pin | Electrical type | Function |
|---|---|---|
VCC | Power input | Supply |
GND | Power input | Supply |
IN1 | Input | GPIO |
IN2 | Input | GPIO |
IN3 | Input | GPIO |
IN4 | Input | GPIO |
OUT1 | Passive | — |
OUT2 | Passive | — |
OUT3 | Passive | — |
OUT4 | Passive | — |
All Board I/O modules · All parts
Modelled from TI ULN2003A Darlington array datasheet.