Water Level Sensor

The Water Level Sensor is a board I/O module in the LabWired part catalog. Its catalog type is water-level. It connects to the MCU over GPIO. The catalog gives a supply range of 3.3–5 V. It has 3 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

From the catalog: S is ADC level; water height is host SimInput.

Key facts

Category	Board I/O modules
Catalog type	water-level
Interface	GPIO
Supply range	3.3–5 V
Pins	3

What LabWired simulates

Water Level Sensor pinout

• Power: VCC, GND
• Other signals: S

How to simulate the Water Level Sensor in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the Water Level Sensor (catalog type water-level).
3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 3.3–5 V.
4. Connect S as your circuit needs.
5. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

• 28BYJ-48 Stepper GPIO · Built from the datasheet
• Vibration Sensor GPIO · Pins only, by design
• 4-Channel Relay GPIO · Pins only, by design
• ULN2003 / 28BYJ-48 stepper GPIO · Built from the datasheet
• 7-Segment Display (single digit) GPIO · Built from the datasheet
• TTP223 Touch Sensor GPIO · Pins only, by design
• ACS712 Current Sensor GPIO · Pins only, by design
• toggle-switch GPIO · Built from the datasheet

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.