Cobalt F405: PCB routing and verification
Design a PCB through MCP. Test its analog and firmware behavior.
Starting from the original 75 footprints, LabWired rerouted the Cobalt F405 flight controller. We ran STM32 firmware on the recovered I²C paths and checked the battery-sense divider with a separate ngspice DC model.
Explore PCB routing and verification
Replay shows 781 trace segments and 54 vias in an illustrative order. Ground pours are hidden to expose the traces.
Open Inputs and set the TMP117 temperature. D1 lights blue below 37.5 °C. D2 lights green at 37.5 °C and above.
The simulated bench tested the J6 connector and LED paths. With SDA intact, an external TMP117 returned its temperature. Removing one trace between J6 and PB7 stopped both the TMP117 and a separate BME280 from answering.
On the copper path from J2.7 to PB0, ngspice calculated 0.800 V from a 16.8 V input through the board’s 20 kΩ / 1 kΩ divider. Cutting the feed dropped the modeled voltage to 0 V.
Independent KiCad checksKiCad 9.0.9 reported zero DRC errors, zero missing connections and zero schematic differences. Of the 61 library warnings, 57 concern footprints that differ from the installed library and four concern an unavailable custom library. The assembly still needs a USB-C fit check. HCTL recommends a 0.80 mm board for the connector, while Cobalt uses 1.60 mm.
Watch the eight-layer LPDDR4 breakout 200-ball BGA · 460 pads · 29 signal nets
Follow 16 data signals and 13 strobe, clock, command and control signals from a Micron BGA to a 260-pad edge connector. The router fits 0.12 mm traces between the pads and changes layers through 83 vias.
Saved routing result. Freerouting left three connections open after pass one, two after pass two and zero after pass three. The final layout uses 315 trace segments across four of the eight layers. KiCad found zero unconnected pads and reported two missing footprint-library warnings. A separate hosted run with different routing rules left three connections open and reported 234 router violations.
This fixture tests BGA escape geometry. Memory timing, impedance and hardware operation remain unverified. LabWired adapted the pad geometry and signal mapping from Antmicro’s six-layer testbed under Apache 2.0.