DIP Switch

The DIP Switch is a board I/O module in the LabWired part catalog. Its catalog type is dip-switch. It connects to the MCU over GPIO. It has 8 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

Key facts

Category	Board I/O modules
Catalog type	dip-switch
Interface	GPIO
Pins	8

What LabWired simulates

DIP Switch pinout

• Other signals: 1, 2, 3, 4, C1, C2, C3, C4

How to simulate the DIP Switch in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the DIP Switch (catalog type dip-switch).
3. Connect pin 1, pin 2, pin 3, pin 4, C1, C2, C3 and C4 as your circuit needs.
4. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

• DRV8825 Stepper Driver GPIO · Built from the datasheet
• DHT22 / AM2302 GPIO · Built from the datasheet
• DRV8833 Dual H-Bridge Motor Driver GPIO · Pins only, by design
• DHT11 GPIO · Built from the datasheet
• DS18B20 Temperature GPIO · Pins only, by design
• Buzzer GPIO · Pins only, by design
• Flame Sensor GPIO · Pins only, by design
• button-module GPIO · Built from the datasheet

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.