board I/O module

DIP Switch (8-way)

The DIP Switch (8-way) is a board I/O module in the LabWired part catalog. Its catalog type is dip-switch-8. It connects to the MCU over GPIO. It has 16 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

Key facts

Category	Board I/O modules
Catalog type	`dip-switch-8`
Interface	GPIO
Pins	16

What LabWired simulates

What is simulated

Pins only, by design

How it was validated

Not applicable. No device model to validate — see what is simulated, above.

DIP Switch (8-way) pinout

Other signals: 1, 2, 3, 4, 5, 6, 7, 8, C1, C2, C3, C4, C5, C6, C7, C8

Pin	Electrical type	Function
`1`	Passive	—
`2`	Passive	—
`3`	Passive	—
`4`	Passive	—
`5`	Passive	—
`6`	Passive	—
`7`	Passive	—
`8`	Passive	—
`C1`	Passive	—
`C2`	Passive	—
`C3`	Passive	—
`C4`	Passive	—
`C5`	Passive	—
`C6`	Passive	—
`C7`	Passive	—
`C8`	Passive	—

How to simulate the DIP Switch (8-way) in LabWired

Open the Playground at app.labwired.com and place an MCU board.
Add the DIP Switch (8-way) (catalog type dip-switch-8).
Connect pin 1, pin 2, pin 3, pin 4, pin 5, pin 6, pin 7, pin 8, C1, C2, C3, C4, C5, C6, C7 and C8 as your circuit needs.
Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.

Wire it up in Playground → See the full validation matrix