LabWired The easy way to build hardware
board I/O module

LM393 Moisture Module

The LM393 Moisture Module is a board I/O module in the LabWired part catalog. Its catalog type is lm393-moisture. It connects to the MCU over GPIO. The catalog gives a supply range of 3.3–5 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

LM393 Moisture Module in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typelm393-moisture
InterfaceGPIO
Supply range3.3–5 V
Pins4

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

LM393 Moisture Module pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
DOUT Output GPIO
AOUT Passive —

How to simulate the LM393 Moisture Module in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the LM393 Moisture Module (catalog type lm393-moisture).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 3.3–5 V.
  4. Connect DOUT to a free GPIO pin.
  5. Connect AOUT as your circuit needs.
  6. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts