L293D

The L293D is a board I/O module in the LabWired part catalog. Its catalog type is l293d. It connects to the MCU over GPIO. It has 16 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Key facts

Category	Board I/O modules
Catalog type	l293d
Interface	GPIO
Pins	16
Datasheet	Texas Instruments L293x quadruple half-H driver datasheet

What LabWired simulates

L293D pinout

• Other signals: L1, L2, L3, L4, L5, L6, L7, L8, R1, R2, R3, R4, R5, R6, R7, R8

How to simulate the L293D in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the L293D (catalog type l293d).
3. Connect L1, L2, L3, L4, L5, L6, L7, L8, R1, R2, R3, R4, R5, R6, R7 and R8 as your circuit needs.
4. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

• L9110S Dual H-Bridge Motor Driver GPIO · Pins only, by design
• IRF520 MOSFET Module GPIO · Pins only, by design
• LED GPIO · Pins only, by design
• IR Obstacle Sensor GPIO · Pins only, by design
• Matrix keypad GPIO · Built from the datasheet
• INMP441 I2S Mic SPI · Built from the datasheet
• MAX98357 I2S Amp GPIO · Pins only, by design
• ILI9341 TFT (16-bit parallel) GPIO · Built from the datasheet

All Board I/O modules · All parts

Modelled from Texas Instruments L293x quadruple half-H driver datasheet.