IRF520 MOSFET Module

The IRF520 MOSFET Module is a board I/O module in the LabWired part catalog. Its catalog type is irf520. It connects to the MCU over GPIO. It has 5 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

Key facts

Category	Board I/O modules
Catalog type	irf520
Interface	GPIO
Pins	5

What LabWired simulates

IRF520 MOSFET Module pinout

• Power: VCC, GND
• GPIO: SIG
• Other signals: VIN, V-

How to simulate the IRF520 MOSFET Module in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the IRF520 MOSFET Module (catalog type irf520).
3. Connect VCC and GND to the supply and ground of the board.
4. Connect SIG to a free GPIO pin.
5. Connect VIN and V- as your circuit needs.
6. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

• L293D GPIO · Built from the datasheet
• IR Obstacle Sensor GPIO · Pins only, by design
• L9110S Dual H-Bridge Motor Driver GPIO · Pins only, by design
• INMP441 I2S Mic SPI · Built from the datasheet
• LED GPIO · Pins only, by design
• ILI9341 TFT (16-bit parallel) GPIO · Built from the datasheet
• Matrix keypad GPIO · Built from the datasheet
• HX711 Load Cell GPIO · Built from the datasheet

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.