LabWired The easy way to build hardware
SPI device

RM67162 AMOLED

The RM67162 AMOLED is an SPI device in the LabWired part catalog. Its catalog type is amoled-rm67162. It connects to the MCU over SPI. It has 7 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Key facts

CategorySPI devices
Catalog typeamoled-rm67162
InterfaceSPI
Pins7
DatasheetRaydium RM67162 single chip driver with 16.7M color for 480RGBx480 OLED driver data sheet Rev. 0.0

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

RM67162 AMOLED pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
CS Input SPI chip select (CS)
RESET Input GPIO
DC Input GPIO
MOSI Input SPI data out of the MCU (MOSI)
SCK Input SPI clock (SCK)

How to simulate the RM67162 AMOLED in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the RM67162 AMOLED (catalog type amoled-rm67162).
  3. Connect VCC and GND to the supply and ground of the board.
  4. Connect SCK and MOSI to the SPI pins of the board.
  5. Connect CS to the chip-select pin of the board, or to a free GPIO.
  6. Connect RESET and DC to free GPIO pins.
  7. Run the firmware. It selects the part and moves bytes over the simulated SPI bus as on hardware.

Related SPI devices

All SPI devices · All parts

Modelled from Raydium RM67162 single chip driver with 16.7M color for 480RGBx480 OLED driver data sheet Rev. 0.0.

Wire it up in Playground → See the full validation matrix