pmos

The pmos is a passive, analog or power part in the LabWired part catalog. Its catalog type is pmos. It has 3 pins. No device model of its own. On a signal net it is an element of the in-core analog circuit, solved next to the running firmware; wired only across supply rails (a decoupling capacitor, for example) it stays wiring only. Semiconductor models are large-signal, with no device capacitance.

From the catalog: Shichman-Hodges level-1 MOSFET in the in-core MNA (M line), bulk tied to source unless the diagram wires a B pin. No overlap or junction charge, no body effect.

Key facts

What LabWired simulates

pmos pinout

• Other signals: D, G, S

How to simulate the pmos in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the pmos (catalog type pmos).
3. Connect D, G and S as your circuit needs.
4. Run the firmware. When the part is in an analog circuit, as described above, the in-core analog solver computes it next to the firmware.

Related Passive, analog and power parts

• pnp Analog circuit element
• pin-header Wiring only
• Potentiometer Analog (ADC) · Built from the datasheet
• Photoresistor (LDR) Analog (ADC) · Built from the datasheet
• Resistor Analog circuit element
• opamp Analog circuit element
• Sharp GP2Y0A21 IR Distance Sensor Analog (ADC) · Built from the datasheet
• NTC Thermistor Analog (ADC) · Built from the datasheet

All Passive, analog and power parts · All parts

Modelled from Infineon IRF9540N MOSFET datasheet.