LabWired The easy way to build hardware
board I/O module

28BYJ-48 Stepper

The 28BYJ-48 Stepper is a board I/O module in the LabWired part catalog. Its catalog type is stepper-28byj48. It connects to the MCU over GPIO. The catalog gives a supply range of 5–12 V. It has 6 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

28BYJ-48 Stepper in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typestepper-28byj48
InterfaceGPIO
Supply range5–12 V
Pins6
Datasheet28BYJ-48 stepper motor datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

28BYJ-48 Stepper pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
IN1 Input GPIO
IN2 Input GPIO
IN3 Input GPIO
IN4 Input GPIO

How to simulate the 28BYJ-48 Stepper in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the 28BYJ-48 Stepper (catalog type stepper-28byj48).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 5–12 V.
  4. Connect IN1, IN2, IN3 and IN4 to free GPIO pins.
  5. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts

Modelled from 28BYJ-48 stepper motor datasheet.