I²C device

ADXL345 Tilt

The ADXL345 Tilt is an I²C device in the LabWired part catalog. Its catalog type is adxl345. It connects to the MCU over I²C at the default address 0x53. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Key facts

Category	I²C devices
Catalog type	`adxl345`
Interface	I²C
Default I²C address	`0x53` (83 decimal)
Pins	4
Datasheet	Analog Devices ADXL345 datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

ADXL345 Tilt pinout

Power: VCC, GND
I²C: SDA, SCL

Pin	Electrical type	Function
`VCC`	Power input	Supply
`GND`	Power input	Supply
`SDA`	Open-drain	I²C data (SDA)
`SCL`	Open-drain	I²C clock (SCL)

How to simulate the ADXL345 Tilt in LabWired

Open the Playground at app.labwired.com and place an MCU board.
Add the ADXL345 Tilt (catalog type adxl345).
Connect VCC and GND to the supply and ground of the board.
Connect SDA and SCL to the I²C data and clock pins of the board.
Run the firmware. It finds the part on the I²C bus at 0x53 and reads and writes it as on hardware.

Related I²C devices

All I²C devices · All parts