LabWired The easy way to build hardware
I²C device

AS5600 Magnetic Encoder

The AS5600 Magnetic Encoder is an I²C device in the LabWired part catalog. Its catalog type is as5600. It connects to the MCU over I²C at the default address 0x36. The catalog gives a supply range of 3–5.5 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Key facts

CategoryI²C devices
Catalog typeas5600
InterfaceI²C
Default I²C address0x36 (54 decimal)
Supply range3–5.5 V
Pins4
Datasheetams AS5600 datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

AS5600 Magnetic Encoder pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
SDA Open-drain I²C data (SDA)
SCL Open-drain I²C clock (SCL)

How to simulate the AS5600 Magnetic Encoder in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the AS5600 Magnetic Encoder (catalog type as5600).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 3–5.5 V.
  4. Connect SDA and SCL to the I²C data and clock pins of the board.
  5. Run the firmware. It finds the part on the I²C bus at 0x36 and reads and writes it as on hardware.

Related I²C devices

All I²C devices · All parts

Further reading

Modelled from ams AS5600 datasheet.

Wire it up in Playground → See the full validation matrix