LabWired The easy way to build hardware
board I/O module

Push Button

The Push Button is a board I/O module in the LabWired part catalog. Its catalog type is button. It connects to the MCU over GPIO. It has 2 pins. A device model in the simulation engine, reached through a dedicated dispatch path rather than the peripheral registry.

From the catalog: Materialised from the part's `board_io` binding (not external_devices — a passive contact has no device block), so it is absent from the generated manifest. Drives the pin the firmware samples, honouring the wire-derived active_high. SimInput channel: pressed.

Push Button in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typebutton
InterfaceGPIO
Pins2
DatasheetOmron B3F tactile switch datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

Push Button pinout

PinElectrical typeFunction
1 Passive —
2 Passive —

How to simulate the Push Button in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the Push Button (catalog type button).
  3. Connect pin 1 and pin 2 as your circuit needs.
  4. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts

Modelled from Omron B3F tactile switch datasheet.