RGB LED

The RGB LED is a board I/O module in the LabWired part catalog. Its catalog type is rgb-led. It connects to the MCU over GPIO. It has 4 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

Key facts

Category	Board I/O modules
Catalog type	rgb-led
Interface	GPIO
Pins	4

What LabWired simulates

RGB LED pinout

• Other signals: R, G, B, GND

How to simulate the RGB LED in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the RGB LED (catalog type rgb-led).
3. Connect R, G, B and GND as your circuit needs.
4. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

• Rotary Encoder GPIO · Built from the datasheet
• Rain Sensor GPIO · Pins only, by design
• Slide Switch GPIO · Built from the datasheet
• Push Button GPIO · Built from the datasheet
• Sound Sensor GPIO · Pins only, by design
• PIR Sensor GPIO · Pins only, by design
• STEP/DIR stepper driver GPIO · Built from the datasheet
• MQ-2 Gas Sensor GPIO · Pins only, by design

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.