nmos

The nmos is a passive, analog or power part in the LabWired part catalog. Its catalog type is nmos. It has 3 pins. No device model of its own. On a signal net it is an element of the in-core analog circuit, solved next to the running firmware; wired only across supply rails (a decoupling capacitor, for example) it stays wiring only. Semiconductor models are large-signal, with no device capacitance.

From the catalog: Shichman-Hodges level-1 MOSFET in the in-core MNA (M line), bulk tied to source unless the diagram wires a B pin. No overlap or junction charge, no body effect.

Key facts

What LabWired simulates

nmos pinout

• GPIO: G
• Other signals: D, S

How to simulate the nmos in LabWired

1. Open the Playground at app.labwired.com and place an MCU board.
2. Add the nmos (catalog type nmos).
3. Connect G to a free GPIO pin.
4. Connect D and S as your circuit needs.
5. Run the firmware. When the part is in an analog circuit, as described above, the in-core analog solver computes it next to the firmware.

Related Passive, analog and power parts

• npn Analog circuit element
• nema17 Built from the datasheet
• NTC Thermistor Analog (ADC) · Built from the datasheet
• MT3608 Boost Converter Wiring only
• opamp Analog circuit element
• MQ-6 Gas Sensor Analog (ADC) · Built from the datasheet
• Photoresistor (LDR) Analog (ADC) · Built from the datasheet
• MP1584 Buck Converter Wiring only

All Passive, analog and power parts · All parts

Modelled from Infineon IRLZ44N MOSFET datasheet.