board I/O module

7-Segment Display (single digit)

The 7-Segment Display (single digit) is a board I/O module in the LabWired part catalog. Its catalog type is seven-segment. It connects to the MCU over GPIO. It has 9 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Key facts

Category	Board I/O modules
Catalog type	`seven-segment`
Interface	GPIO
Pins	9

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

7-Segment Display (single digit) pinout

GPIO: A, B, C, D, E, F, G, DP, COM

Pin	Electrical type	Function
`A`	Input	GPIO
`B`	Input	GPIO
`C`	Input	GPIO
`D`	Input	GPIO
`E`	Input	GPIO
`F`	Input	GPIO
`G`	Input	GPIO
`DP`	Input	GPIO
`COM`	Input	GPIO

How to simulate the 7-Segment Display (single digit) in LabWired

Open the Playground at app.labwired.com and place an MCU board.
Add the 7-Segment Display (single digit) (catalog type seven-segment).
Connect A, B, C, D, E, F, G, DP and COM to free GPIO pins.
Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.

Wire it up in Playground → See the full validation matrix