LabWired The easy way to build hardware
board I/O module

ACS712 Current Sensor (5 A)

The ACS712 Current Sensor (5 A) is a board I/O module in the LabWired part catalog. Its catalog type is acs712. It connects to the MCU over Analog (ADC). The catalog gives a supply range of 4.5–5.5 V. It has 3 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

From the catalog: OUT currently uses ADC pin I/O. Core registers an ACS712 current-transfer model, but the canvas emitter does not attach it yet.

ACS712 Current Sensor (5 A) in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typeacs712
InterfaceAnalog (ADC)
Supply range4.5–5.5 V
Pins3
DatasheetAllegro ACS712 current sensor datasheet

What LabWired simulates

What is simulated

Pins only, by design

How it was validated

Not applicable

ACS712 Current Sensor (5 A) pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
OUT Passive —

How to simulate the ACS712 Current Sensor (5 A) in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the ACS712 Current Sensor (5 A) (catalog type acs712).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 4.5–5.5 V.
  4. Connect OUT as your circuit needs.
  5. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

All Board I/O modules · All parts

Modelled from Allegro ACS712 current sensor datasheet.