logic IC

74HC08 Quad AND

The 74HC08 Quad AND is a logic IC in the LabWired part catalog. Its catalog type is 74hc08. It connects to the MCU over GPIO. The catalog gives a supply range of 2–6 V. It has 14 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: Quad 2-input AND (core/configs/devices/74hc08.yaml), 8 ns.

Key facts

Category	Logic ICs
Catalog type	`74hc08`
Interface	GPIO
Supply range	2–6 V
Pins	14
Datasheet	Nexperia 74HC08 / 74HCT08 datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

74HC08 Quad AND pinout

Power: VCC, GND
Other signals: A1, B1, Y1, A2, B2, Y2, A3, B3, Y3, A4, B4, Y4

Pin	Electrical type	Function
`A1`	Input	—
`B1`	Input	—
`Y1`	Output	—
`A2`	Input	—
`B2`	Input	—
`Y2`	Output	—
`A3`	Input	—
`B3`	Input	—
`Y3`	Output	—
`A4`	Input	—
`B4`	Input	—
`Y4`	Output	—
`VCC`	Power input	Supply
`GND`	Power input	Supply

How to simulate the 74HC08 Quad AND in LabWired

Open the Playground at app.labwired.com and place an MCU board.
Add the 74HC08 Quad AND (catalog type 74hc08).
Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 2–6 V.
Connect A1, B1, Y1, A2, B2, Y2, A3, B3, Y3, A4, B4 and Y4 as your circuit needs.
Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Logic ICs

All Logic ICs · All parts

Modelled from Nexperia 74HC08 / 74HCT08 datasheet.

Wire it up in Playground → See the full validation matrix