LabWired The easy way to build hardware
passive, analog or power part

iolink-transceiver

The iolink-transceiver is a passive, analog or power part in the LabWired part catalog. Its catalog type is iolink-transceiver. It has 6 pins. Placeable and checked electrically (nets, rails, connectivity), but it has no runtime behaviour of its own.

iolink-transceiver in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryPassive, analog and power parts
Catalog typeiolink-transceiver
Pins6
DatasheetTI SN65HVD101 IO-Link transceiver datasheet

What LabWired simulates

What is simulated

Wiring only

How it was validated

Not applicable

iolink-transceiver pinout

PinElectrical typeFunction
TXD Input UART receive (RX)
RXD Output UART transmit (TX)
VCC Power input Supply
GND Power input Supply
CQ Bidirectional —
L+ Power input Supply

How to simulate the iolink-transceiver in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the iolink-transceiver (catalog type iolink-transceiver).
  3. Connect VCC, GND and L+ to the supply and ground of the board.
  4. Cross the UART lines: connect RXD to the RX pin of the board, and TXD to the TX pin of the board.
  5. Connect CQ as your circuit needs.
  6. The part has no runtime behaviour. LabWired checks its wiring: nets, rails and connectivity.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

Modelled from TI SN65HVD101 IO-Link transceiver datasheet.