LabWired The easy way to build hardware
passive, analog or power part

LiPo battery + charger

The LiPo battery + charger is a passive, analog or power part in the LabWired part catalog. Its catalog type is lipo_charger. It connects to the MCU over Analog (ADC). The catalog gives a supply range of 3.3–4.2 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: Analog LiPo/charge-controller kit (core LIPO_CHARGER_KIT) — pack voltage on an ADC pin + charge line, driven via SimInput (soc_pct/usb_present). MCU-agnostic; placeable on any board with an ADC.

Key facts

CategoryPassive, analog and power parts
Catalog typelipo_charger
InterfaceAnalog (ADC)
Supply range3.3–4.2 V
Pins4

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

LiPo battery + charger pinout

PinElectrical typeFunction
BAT+ Passive —
GND Power input Supply
ADC Passive —
CHRG Output GPIO

How to simulate the LiPo battery + charger in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the LiPo battery + charger (catalog type lipo_charger).
  3. Connect GND to the supply and ground of the board. Use a supply inside the catalog range of 3.3–4.2 V.
  4. Connect CHRG to a free GPIO pin.
  5. Connect BAT+ and ADC as your circuit needs.
  6. Run the firmware. It reads the output of the part with the ADC of the MCU.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.

Wire it up in Playground → See the full validation matrix