LabWired The easy way to build hardware
passive, analog or power part

lm393

The lm393 is a passive, analog or power part in the LabWired part catalog. Its catalog type is lm393. The catalog gives a supply range of 2–36 V. It has 8 pins. No device model of its own. On a signal net it is an element of the in-core analog circuit, solved next to the running firmware; wired only across supply rails (a decoupling capacitor, for example) it stays wiring only. Semiconductor models are large-signal, with no device capacitance.

From the catalog: Dual open-collector comparator: one X line per wired unit, core LM393 card (AOL 200 V/mV, 37.5 ohm sink). Needs a pull-up on each output, as the real part does.

lm393 in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryPassive, analog and power parts
Catalog typelm393
Supply range2–36 V
Pins8
DatasheetTexas Instruments LM393, LM2903 datasheet

What LabWired simulates

What is simulated

Analog circuit element

How it was validated

Not applicable

lm393 pinout

PinElectrical typeFunction
INA+ Passive —
INA- Passive —
OUTA Passive —
INB+ Passive —
INB- Passive —
OUTB Passive —
V+ Passive —
V- Passive —

How to simulate the lm393 in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the lm393 (catalog type lm393).
  3. Connect INA+, INA-, OUTA, INB+, INB-, OUTB, V+ and V- as your circuit needs.
  4. Run the firmware. When the part is in an analog circuit, as described above, the in-core analog solver computes it next to the firmware.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

Modelled from Texas Instruments LM393, LM2903 datasheet.