LabWired The easy way to build hardware
passive, analog or power part

4-ch Level Shifter

The 4-ch Level Shifter is a passive, analog or power part in the LabWired part catalog. Its catalog type is logic-level-shifter-4ch. The catalog gives a supply range of 1.8–6 V. It has 12 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: logic_gate transceiver (descriptor logic_level_shifter_4ch). DIR is a sim strap, not a PCB pin. Translation is a bit copy — this engine has no voltage domains.

4-ch Level Shifter (generic representation)
Generic editor representation · no part-specific renderer is registered.

Key facts

CategoryPassive, analog and power parts
Catalog typelogic-level-shifter-4ch
Supply range1.8–6 V
Pins12

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

4-ch Level Shifter pinout

PinElectrical typeFunction
VCCA Power input Supply
VCCB Power input Supply
GND Power input Supply
DIR Input GPIO
A1 Bidirectional —
A2 Bidirectional —
A3 Bidirectional —
A4 Bidirectional —
B1 Bidirectional —
B2 Bidirectional —
B3 Bidirectional —
B4 Bidirectional —

How to simulate the 4-ch Level Shifter in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the 4-ch Level Shifter (catalog type logic-level-shifter-4ch).
  3. Connect VCCA, VCCB and GND to the supply and ground of the board. Use a supply inside the catalog range of 1.8–6 V.
  4. Connect DIR to a free GPIO pin.
  5. Connect A1, A2, A3, A4, B1, B2, B3 and B4 as your circuit needs.
  6. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts