LabWired The easy way to build hardware
passive, analog or power part

XL4015 CC/CV buck

The XL4015 CC/CV buck is a passive, analog or power part in the LabWired part catalog. Its catalog type is xl4015. It connects to the MCU over Analog (ADC). It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: analog_source kit. Vout setpoint is observed through a ÷11 ADC divider. ilim_a is recorded and does not bend Vout. OUT+ selects the ADC channel when wired.

XL4015 CC/CV buck (generic representation)
Generic editor representation · no part-specific renderer is registered.

Key facts

CategoryPassive, analog and power parts
Catalog typexl4015
InterfaceAnalog (ADC)
Pins4
DatasheetXLSEMI XL4015 datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

XL4015 CC/CV buck pinout

PinElectrical typeFunction
IN+ Power input Supply
IN- Power input Supply
OUT+ power_out —
OUT- power_out —

How to simulate the XL4015 CC/CV buck in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the XL4015 CC/CV buck (catalog type xl4015).
  3. Connect IN+ and IN- to the supply and ground of the board.
  4. Connect OUT+ and OUT- as your circuit needs.
  5. Run the firmware. It reads the output of the part with the ADC of the MCU.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

Modelled from XLSEMI XL4015 datasheet.