LabWired The easy way to build hardware
passive, analog or power part

zener

The zener is a passive, analog or power part in the LabWired part catalog. Its catalog type is zener. It has 2 pins. No device model of its own. On a signal net it is an element of the in-core analog circuit, solved next to the running firmware; wired only across supply rails (a decoupling capacitor, for example) it stays wiring only. Semiconductor models are large-signal, with no device capacitance.

From the catalog: Level-1 diode with reverse breakdown (D line, BV/IBV). Core card 1N4733A: VZ 5.09 V at IZT 49 mA, ZZ 6.6 ohm. Other voltages from a name that states one (BZX84C3V3, 12V) or attrs.model_params.

zener in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryPassive, analog and power parts
Catalog typezener
Pins2
DatasheetVishay 1N4728A to 1N4764A zener diodes datasheet

What LabWired simulates

What is simulated

Analog circuit element

How it was validated

Not applicable

zener pinout

PinElectrical typeFunction
A Passive —
K Passive —

How to simulate the zener in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the zener (catalog type zener).
  3. Connect A and K as your circuit needs.
  4. Run the firmware. When the part is in an analog circuit, as described above, the in-core analog solver computes it next to the firmware.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

Modelled from Vishay 1N4728A to 1N4764A zener diodes datasheet.