nano-33-iot

The nano-33-iot is an MCU board in the LabWired part catalog. Its catalog type is nano-33-iot. Silicon coverage for this board is tracked in the chip × peripheral validation matrix, not per-part.

Key facts

Category	MCU boards
Catalog type	nano-33-iot
Datasheet	SAM D21/DA1 Family Data Sheet (DS40001882)

What LabWired simulates

How to simulate the nano-33-iot in LabWired

1. Open the Playground at app.labwired.com and select the nano-33-iot as the board.
2. Write the firmware, then build it and run it.
3. Add parts from the catalog and connect them to the board pins. The categories below list the parts by bus.
4. Before you trust a result, look at the validation matrix. It shows which chip peripherals are modelled and how each one was checked.

Parts to connect to the nano-33-iot

• I²C devices (43)
• SPI devices (19)
• UART devices (8)
• Board I/O modules (55)
• Logic ICs (8)
• Passive, analog and power parts (40)
• Wireless (1)

Related MCU boards

• nrf52-dk datasheet linked
• microbit-v2 datasheet linked
• nRF52840 DK datasheet linked
• metro-m4 datasheet linked
• nrf5340-dk datasheet linked
• MCU
• nrf54l15 datasheet linked
• Luckfox Pico Mini A Not modelled

All MCU boards · All parts

Modelled from SAM D21/DA1 Family Data Sheet (DS40001882).