LabWired The easy way to build hardware
board I/O module

BLDC Hall Driver

The BLDC Hall Driver is a board I/O module in the LabWired part catalog. Its catalog type is bldc-hall-driver. It connects to the MCU over GPIO. The catalog gives a supply range of 6–60 V. It has 11 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: compile emits the bldc_hall_driver descriptor (device_type bldc-hall-driver). PWM/DIR/ENABLE in, 6-step Hall pattern out. Duty→RPM is not modelled.

BLDC Hall Driver (generic representation)
Generic editor representation · no part-specific renderer is registered.

Key facts

CategoryBoard I/O modules
Catalog typebldc-hall-driver
InterfaceGPIO
Supply range6–60 V
Pins11

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

BLDC Hall Driver pinout

PinElectrical typeFunction
VM Power input Supply
GND Power input Supply
PWM Input PWM
DIR Input GPIO
ENABLE Input GPIO
HALL_A Output —
HALL_B Output —
HALL_C Output —
U Passive —
V Passive —
W Passive —

How to simulate the BLDC Hall Driver in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the BLDC Hall Driver (catalog type bldc-hall-driver).
  3. Connect VM and GND to the supply and ground of the board. Use a supply inside the catalog range of 6–60 V.
  4. Connect PWM to a pin that can output PWM.
  5. Connect DIR and ENABLE to free GPIO pins.
  6. Connect HALL_A, HALL_B, HALL_C, U, V and W as your circuit needs.
  7. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts