LabWired The easy way to build hardware
board I/O module

Analog Joystick

The Analog Joystick is a board I/O module in the LabWired part catalog. Its catalog type is joystick. It connects to the MCU over Analog (ADC). The catalog gives a supply range of 3.3–5 V. It has 5 pins. This part is its pins. There is no separate device model because the MCU’s own GPIO/PWM/ADC model already is the simulation.

From the catalog: VRX/VRY lower to separate potentiometer kits (<id>:x/y, position 0..100); SW remains a digital pad. The combined core joystick kit is not yet emitted.

Analog Joystick in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryBoard I/O modules
Catalog typejoystick
InterfaceAnalog (ADC)
Supply range3.3–5 V
Pins5

What LabWired simulates

What is simulated

Pins only, by design

How it was validated

Not applicable

Analog Joystick pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
VRX Passive —
VRY Passive —
SW Output GPIO

How to simulate the Analog Joystick in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the Analog Joystick (catalog type joystick).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 3.3–5 V.
  4. Connect SW to a free GPIO pin.
  5. Connect VRX and VRY as your circuit needs.
  6. Run the firmware. It reads and drives these pins through the GPIO, PWM and ADC models of the MCU. The part has no separate device model.

Related Board I/O modules

All Board I/O modules · All parts