LabWired The easy way to build hardware
MCU board

Arduino Nano (ATmega328P)

The Arduino Nano (ATmega328P) is an MCU board in the LabWired part catalog. Its catalog type is arduino-nano. Silicon coverage for this board is tracked in the chip × peripheral validation matrix, not per-part.

Arduino Nano (ATmega328P) in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryMCU boards
Catalog typearduino-nano
DatasheetATmega328P datasheet

What LabWired simulates

What is simulated

MCU board

How it was validated

Not applicable

How to simulate the Arduino Nano (ATmega328P) in LabWired

  1. Open the Playground at app.labwired.com and select the Arduino Nano (ATmega328P) as the board.
  2. Write the firmware, then build it and run it.
  3. Add parts from the catalog and connect them to the board pins. The categories below list the parts by bus.
  4. Before you trust a result, look at the validation matrix. It shows which chip peripherals are modelled and how each one was checked.

Parts to connect to the Arduino Nano (ATmega328P)

Related MCU boards

All MCU boards · All parts

Further reading

Modelled from ATmega328P datasheet.