LabWired The easy way to build hardware
board I/O module

BTS7960 H-Bridge

The BTS7960 H-Bridge is a board I/O module in the LabWired part catalog. Its catalog type is bts7960. It connects to the MCU over GPIO. The catalog gives a supply range of 5–27 V. It has 11 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: BTS7960 / IBT-2. compile emits type bts7960 with lpwm_pin/rpwm_pin and optional l_en_pin/r_en_pin. Core TYPE_ALIASES that spelling onto the l298n kit (digital on/off effort; PWM duty is not observed).

BTS7960 H-Bridge (generic representation)
Generic editor representation · no part-specific renderer is registered.

Key facts

CategoryBoard I/O modules
Catalog typebts7960
InterfaceGPIO
Supply range5–27 V
Pins11
DatasheetInfineon BTS7960 datasheet

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

BTS7960 H-Bridge pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
VM Power input Supply
LPWM Input PWM
RPWM Input PWM
L_EN Input GPIO
R_EN Input GPIO
M+ Passive —
M- Passive —
L_IS Output —
R_IS Output —

How to simulate the BTS7960 H-Bridge in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the BTS7960 H-Bridge (catalog type bts7960).
  3. Connect VCC, GND and VM to the supply and ground of the board. Use a supply inside the catalog range of 5–27 V.
  4. Connect LPWM and RPWM to pins that can output PWM.
  5. Connect L_EN and R_EN to free GPIO pins.
  6. Connect M+, M-, L_IS and R_IS as your circuit needs.
  7. Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Board I/O modules

All Board I/O modules · All parts

Modelled from Infineon BTS7960 datasheet.