LabWired The easy way to build hardware
passive, analog or power part

Sound Sensor

The Sound Sensor is a passive, analog or power part in the LabWired part catalog. Its catalog type is sound-sensor. It connects to the MCU over Analog (ADC). The catalog gives a supply range of 3.3–5 V. It has 4 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: A0 is a host-driven 0..100 % sound envelope through the standard SimInput path; not a waveform-accurate acoustic model. D0 is not modelled.

Sound Sensor in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryPassive, analog and power parts
Catalog typesound-sensor
InterfaceAnalog (ADC)
Supply range3.3–5 V
Pins4

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

Sound Sensor pinout

PinElectrical typeFunction
VCC Power input Supply
GND Power input Supply
A0 Passive —
D0 Output GPIO

How to simulate the Sound Sensor in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the Sound Sensor (catalog type sound-sensor).
  3. Connect VCC and GND to the supply and ground of the board. Use a supply inside the catalog range of 3.3–5 V.
  4. Connect D0 to a free GPIO pin.
  5. Connect A0 as your circuit needs.
  6. Run the firmware. It reads the output of the part with the ADC of the MCU.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts