LabWired The easy way to build hardware
passive, analog or power part

TIOL112

The TIOL112 is a passive, analog or power part in the LabWired part catalog. Its catalog type is tiol112. It connects to the MCU over UART. The catalog gives a supply range of 3–3.6 V. It has 11 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

From the catalog: TIOL112 digital PHY: UART bytes are gated by EN, with C/Q inversion and active-low WAKE/NFAULT states. Separate from the generic transceiver. This does not validate 24 V analog behavior, surge/current/thermal protection, propagation delays, or physical C/Q response timing.

TIOL112 in LabWired
Rendered by the matching LabWired editor component.

Key facts

CategoryPassive, analog and power parts
Catalog typetiol112
InterfaceUART
Supply range3–3.6 V
Pins11
DatasheetTIOL112 IO-Link transceiver datasheet SLLSFJ1D (VSON-10, 3.3 V logic configuration)

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet

TIOL112 pinout

PinElectrical typeFunction
VCC_IN Power input Supply
NFAULT Open-drain GPIO
RX Output UART transmit (TX)
TX Input UART receive (RX)
EN Input GPIO
ILIM_ADJ Input —
L- Power input Supply
CQ Bidirectional —
L+ Power input Supply
WAKE Open-drain GPIO
EP Power input Supply

How to simulate the TIOL112 in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the TIOL112 (catalog type tiol112).
  3. Connect VCC_IN, L-, L+ and EP to the supply and ground of the board. Use a supply inside the catalog range of 3–3.6 V.
  4. Cross the UART lines: connect RX to the RX pin of the board, and TX to the TX pin of the board.
  5. Connect NFAULT, EN and WAKE to free GPIO pins.
  6. Connect ILIM_ADJ and CQ as your circuit needs.
  7. Run the firmware. It sends and receives bytes on the simulated UART as on hardware.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

Modelled from TIOL112 IO-Link transceiver datasheet SLLSFJ1D (VSON-10, 3.3 V logic configuration).