LabWired The easy way to build hardware
passive, analog or power part

SN65HVD230 CAN

The SN65HVD230 CAN is a passive, analog or power part in the LabWired part catalog. Its catalog type is sn65hvd230. The catalog gives a supply range of 3–3.6 V. It has 6 pins. Placeable and checked electrically (nets, rails, connectivity), but it has no runtime behaviour of its own.

From the catalog: Passive on the wire: the CAN controller on each node carries the frames, and the world joins the nodes whose CANH/CANL nets are shared (deriveCanBuses). No analog bus levels, slope control or standby (Rs) pin.

Key facts

CategoryPassive, analog and power parts
Catalog typesn65hvd230
Supply range3–3.6 V
Pins6
DatasheetTexas Instruments SN65HVD230, SN65HVD231, SN65HVD232 3.3-V CAN transceivers (SLOS346)

What LabWired simulates

What is simulated

Wiring only

How it was validated

Not applicable. No device model to validate — see what is simulated, above.

SN65HVD230 CAN pinout

PinElectrical typeFunction
3V3 Power input Supply
GND Power input Supply
CRX Output —
CTX Input —
CANL Passive —
CANH Passive —

How to simulate the SN65HVD230 CAN in LabWired

  1. Open the Playground at app.labwired.com and place an MCU board.
  2. Add the SN65HVD230 CAN (catalog type sn65hvd230).
  3. Connect 3V3 and GND to the supply and ground of the board. Use a supply inside the catalog range of 3–3.6 V.
  4. Connect CRX, CTX, CANL and CANH as your circuit needs.
  5. The part has no runtime behaviour. LabWired checks its wiring: nets, rails and connectivity.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

Modelled from Texas Instruments SN65HVD230, SN65HVD231, SN65HVD232 3.3-V CAN transceivers (SLOS346).

Wire it up in Playground → See the full validation matrix