passive, analog or power part

slide-potentiometer

The slide-potentiometer is a passive, analog or power part in the LabWired part catalog. Its catalog type is slide-potentiometer. It has 3 pins. A registered peripheral model runs in the engine: the firmware talks to it over the real bus and gets device-accurate responses.

Key facts

Category	Passive, analog and power parts
Catalog type	`slide-potentiometer`
Pins	3

What LabWired simulates

What is simulated

Simulated device model

How it was validated

Built from the datasheet. Implemented from the part’s register documentation and exercised by automated tests. Nothing physical was ever placed next to it.

slide-potentiometer pinout

Other signals: 1, W, 2

Pin	Electrical type	Function
`1`	Passive	—
`W`	Passive	adc
`2`	Passive	—

How to simulate the slide-potentiometer in LabWired

Open the Playground at app.labwired.com and place an MCU board.
Add the slide-potentiometer (catalog type slide-potentiometer).
Connect pin 1, W and pin 2 as your circuit needs.
Run the firmware. It drives and reads the pins of the part, and the device model responds on those pins.

Related Passive, analog and power parts

All Passive, analog and power parts · All parts

No manufacturer datasheet is indexed for this part yet, so none is linked here.

Wire it up in Playground → See the full validation matrix