ESP32

The ESP32 is an MCU board in the LabWired part catalog. Its catalog type is esp32. Silicon coverage for this board is tracked in the chip × peripheral validation matrix, not per-part.

Key facts

Category	MCU boards
Catalog type	esp32
Datasheet	ESP32 series datasheet

What LabWired simulates

How to simulate the ESP32 in LabWired

1. Open the Playground at app.labwired.com and select the ESP32 as the board.
2. Write the firmware, then build it and run it.
3. Add parts from the catalog and connect them to the board pins. The categories below list the parts by bus.
4. Before you trust a result, look at the validation matrix. It shows which chip peripherals are modelled and how each one was checked.

Parts to connect to the ESP32

• I²C devices (41)
• SPI devices (19)
• UART devices (7)
• Board I/O modules (50)
• Logic ICs (8)
• Passive, analog and power parts (37)
• Wireless (1)

Related MCU boards

• ESP32-C3 Super Mini datasheet linked
• brd2709a datasheet linked
• esp32-c6-devkitc-1 datasheet linked
• arduino-zero datasheet linked
• esp32-s3-devkitc-1 datasheet linked
• arduino-nano datasheet linked
• esp32-s3-devkitc-1-n16r8 datasheet linked
• Arduino Uno R4 Minima datasheet linked

All MCU boards · All parts

Further reading

• Getting started with the ESP32
• Debugging I²C
• Render your Arduino e-paper firmware. You do not need the hardware.
• Blink, a button, and Wi-Fi on the ESP32-S3
• Run your PlatformIO unit tests with no hardware. You install nothing.

Modelled from ESP32 series datasheet.